Leyland Trade Stabilising Masonry Primer Clear 2.5L
![Leyland Trade Stabilising Masonry Primer Clear 2.5L](https://epiccentresupply.co.uk/media/catalog/product/cache/e86d7d28710d9dd711ef9dbab5dc4194/0/1/0169706690065272f94568f63.48940610-leyland-trade-stabilising-masonry-primer-clear-2.5.jpg)
Colour | Clear |
---|---|
Volume | 2.50 |
Truguard Stabilising Masonry Primer
Leyland Truguard Stabilising Masonry Primer is a clear solution for binding down powdery residues on exterior masonry surfaces prior to the application of Truguard water-borne masonry coatings.
Technical Data
Recommended uses
Exterior
Type of substrate
Concrete, cement rendering, brick, stone, blockwork and pebbledash.
Finish
N/A
Volume solid
N/A
Coverage
1 litre will cover approximately 6 square metres depending on the nature and porosity of the surface.
Drying time
Touch dry in 1-2 hours.
Film thickness
N/A
Transportation and storage
To avoid the risk of spillage, always store and transport in a secure upright position. Store away from heat and flame.
Preparation
Ensure surface to be painted is sound, clean, dry and free from grease. Treat any mould or lichen with Sterilisation Wash before removing with a scraper or stiff brush, then treat surface again with Sterilisation Wash and allow to dry. Chalky, underbound surfaces, should be thoroughly scraped and dry brushed. Wear a suitable face mask if creating dust.
Application
Apply by brush one coat of Leyland Stabilising Masonry Primer liberally, brushing the material well into the surface. Allow 16-24 hours to dry and follow with two coats of the selected Truguard Exterior Masonry Coating. Before applying Truguard Stabilising Masonry Primer to the whole surface, first carry out a test application to a small area. If this dries to a glossy film, thin with one part of White Spirit to two parts of Truguard Stabilising Masonry Primer and then test again in another small area. It is important to ensure that a non-glossy, dried, sealed surface is produced.
Cleaning
Remove as much product as possible from application equipment before cleaning. Clean equipment immediately after use with white spirit or turpentine substitute. Some local authorities have special facilities for disposal of waste coatings. Do not empty product into drains or watercourses. Replace lid firmly.
Warning
• Keep out of reach of children.
• Avoid contact with skin and eyes.
• Do not ingest.
• Do not breathe spray. Wear respiratory protection.
• If medical advice is needed have container or label to hand.