Leyland Trade Direct to Metal Paint Silver 750ml

Direct to Metal Paint

A smooth, semi-gloss coating which can be applied direct to bare, previously painted or weathered metal surfaces providing a hardwearing finish.  It offers excellent  anti-corrosive properties whilst maintaining excellent adhesion attributes. For added protection, use in conjunction  with Leyland  Anti-Corrosive Metal Primer. 

Technical Data

Recommended uses

Interior 

Type of substrate

Bare, previously painted or weathered metal surfaces

Finish

Semi-gloss

Volume solid

50%

Coverage

1 litre will cover approximately 10 square metres depending on the nature and porosity of the surface. Strong or contrasting colours may require additional coats. When using more than one tin of a colour in the same area, intermix before use.

Drying time

Recoat after 2 hours

Film thickness

Wet: 111µm Dry: 50µm

Transportation and storage

STORE AWAY FROM HEAT AND FLAME.

To avoid the risk of spillage, always store and transport in a secure upright position. Lift with care - gross weight does not exceed  4 kilograms.

Preparation

All surfaces should be sound, clean, dry and free from grease. Remove any crazed or flaking paint. Rub down sound glossy surfaces with fine waterproof abrasive paper and rinse thoroughly to provide a key. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.

Application

Stir well before use. Apply by brush or roller. The brush should be fully loaded for best results. For optimum performance, apply a second coat approx. 2 hours after the 1st application when the film is touch dry but not fully cured. Depending on conditions, the product should be completely dry after  16-24 hours.

Cleaning

Remove as much product as possible from application equipment before cleaning. Clean equipment immediately after use in White Spirit or Turpentine Substitute. Replace lid firmly. Some local authorities have special facilities for the disposal of waste coatings. Do not empty product into drains or watercourses.

Warning

•  Keep out of reach of children.

•  Avoid contact with skin and eyes.

•  Do not ingest.

•   Do not breathe spray.  Wear respiratory protection.

•   If medical advice is needed have container or label to hand.