Leyland Trade Anti-Corrosive Metal Primer Grey 2.5L

Anti-Corrosive Metal Primer Leyland Trade 

Anti-Corrosive Metal Primer is suitable for use on all metal surfaces. Its anti-corrosive properties make it ideal for helping prevent rust.

Technical Data

Recommended uses

Interior, Exterior

Type of substrate

All types of metal including ferrous metals and all suitably prepared non-ferrous metal.  

Finish

Matt

Volume solid

34%

Coverage

1 litre will cover approximately 1 square  metres, depending on the nature and porosity of the surface.

Drying time

Recoatable after 14-16 hours.

Transportation and storage

To avoid the risk of spillage, always store and transport in a secure upright position. Store away from heat and flame.

Film thickness

Wet: 75µm Dry: 35µm

Preparation

All surfaces to be painted should be clean, dry and free from loose or flaking material. Existing rust or millscale should be removed from iron and steel. Loose or defective paint should be removed, stripping to the bare surface if necessary. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding. Special precautions should be taken during preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.

Application

Stir thoroughly before use. Apply by brush or roller. To ensure the best results the brush should be fully loaded. Do not thin. Cleaning Remove as much product as possible from application equipment before cleaning. Clean equipment immediately after use in White Spirit or Turpentine Substitute. Replace lid firmly. Some local authorities have special facilities for the disposal of waste coatings. Do not empty product into drains or watercourses.   

Warning

•  Keep out of reach of children.

•  Avoid contact with skin and eyes.

•  Do not ingest.

•   If medical advice is needed have container or label to hand.